oUR SERVICES

Commercial Hot-Side Kitchen Equipment Repair

Ranges, ovens, fryers, broilers, griddles, steamers, and holding cabinets serviced as one system, because a cook line rarely fails in isolation. Gas pressure, ignition, and thermostat accuracy get checked across every unit on the run.

Commercial Oven and Range Repair

Uneven bakes, doors that will not seal, convection fans that stall, and burners that spark without catching. Calibration is measured, not estimated, so a 350 setting actually returns 350 across the deck.

Commercial Fryer Repair

High-limit trips, probes reading out of range, drain safety switches locking out the gas valve, and burners that will not stay lit. Probe resistance is bench-tested against the manufacturer chart before anything is condemned.

Commercial Grill and Griddle Repair

Cold zones across a plate, lazy flames, clogged burner ports, and thermostats that never reach setpoint. Each 12-inch section is checked on its own, since one dead zone rarely means the whole appliance failed.

Commercial Refrigeration Repair

Walk-ins, reach-ins, prep tables, and freezers that will not hold 41 degrees. Defrost timers, condenser coils, evaporator fans, and refrigerant charge are checked in order rather than replaced on a hunch.

Commercial Appliance Repair

Dish machines that will not sanitize, ice machines producing nothing, mixers, warmers, and prep equipment. Warewashing temperatures are verified against the thresholds an inspector will use, not the readout on the panel.

Residential Appliance Repair

Washers stopping mid-cycle, dryers running hot without drying, dishwashers leaving standing water, refrigerators cycling constantly, and ovens off by 50 degrees. Diagnosis happens in your kitchen, with the fault demonstrated before parts are ordered.

HVAC Repair and Maintenance

Full-system service for homes and light commercial buildings: airflow, filtration, duct condition, electrical connections, and combustion. La Puente sits in Climate Zone 9, where refrigerant charge verification is a code item on system alterations.

Air Conditioning Repair

No-cool calls, warm air, iced line sets, water dripping through a ceiling, and compressors that hum without starting. Capacitors are read against their rated tolerance instead of swapped because they look suspect.

Heating System Repair

Furnaces blowing cold, pilots that will not stay lit, dirty flame sensors, short cycling, and heat pumps running lukewarm. Heat exchangers get inspected on every no-heat call, because carbon monoxide is not a maybe.

Emergency Appliance and HVAC Repair

A walk-in failing at 9 p.m. is a food-safety clock, not a maintenance item. We take emergency calls 7 days a week and start with the fastest path back to a safe holding temperature.

Preventive Maintenance Programs

Scheduled visits built around your equipment list: coil cleaning, filter changes, calibration checks, gas pressure readings, and documented findings. Manufacturers exclude condenser-related compressor failures from warranty coverage when coils are left dirty.